Find great deals for Omron E5ax Temperature Controller E5ax-a-f. Shop with confidence on eBay!. E5AX-VAA Omron Automation and Safety Controllers datasheet, inventory, & pricing. E5AX-A by Omron | OMRON TEMPERATURE CONTROLLER | Shipping to + countries worldwide.

Author: Vuzahn Zulkik
Country: Guadeloupe
Language: English (Spanish)
Genre: Music
Published (Last): 27 October 2012
Pages: 402
PDF File Size: 9.95 Mb
ePub File Size: 18.72 Mb
ISBN: 195-3-83100-520-1
Downloads: 88328
Price: Free* [*Free Regsitration Required]
Uploader: Mull

Models with communications capabilities also available. The figures show the locations of these switches and the protection switches on the internal mechanisms.

Omron E5ax Temperature Controller E5ax-a-f

Simultaneously press the Up and Down Keys for at least one second. Integral Time Reset Time: The platinum resistance thermometer has burned out or A and B terminals have been short-circuited. Hold down the Level Key again for 2 seconds minimum to display o on the PV display. Main setting, set alarm value Write disabled Read from Temperature Controller Main setting, set alarm value, proportional band, integral time, derivative time, set limit value, process value, valve position, error codes, etc.

Press the Level Key for at least two seconds, confirm that in—t is displayed, and then press the Level Key again for at least two seconds to display the process value and return to the initial display mode. Display Key Press to shift the display to the next parameter. Successively increases the value when held down.


Up Key Press to increase the main setting or other parameters. To convert millimeters into inches, multiply by 0. The factory setting is seconds. If eax difference is too great, a drastic imron will result. ON Sends alarm signal in accordance with the set alarm mode.

Omron E5ax-ah E5AXAH Temperature Controller C | eBay

The following table shows the messages that may be displayed. The factory setting is 0. Alarm hysteresis db Proportional Band: The omeon block of the Temperature Controller is constructed so that the lead wires can be connected to all the terminals from the same direction.

HEA In the interest of product improvement, specifications are subject to change without notice. It is factory-set to position 2 to designate a K-type chromel-alumel thermocouple temperature sensor. The factory setting is Select this function by pressing the Display Key three omon in display level 0. Connect a valve position indicator if required.


Press the Display Key as soon as the valve stops by the limit switch built into the motor. Alarm Indicator Lights when the alarm output is ON.


A maximum of 32 Temperature Controllers can be connected to one host computer using serial communications RS, RS Manual Output Mode Indicator Lights when in manual output mode. Press the E5aax Key to return to sl—l.

Use the specified compensating conductors for thermocouples. The new value will be displayed on the SV display. Usually, the alarm value is set as a deviation from the main setting, but it can also be set as an absolute value when the event alarm mode is selected.

Therefore, take this time delay into consideration when designing sequenced circuits which incorporate a Temperature Controller. Do not install the Temperature Controller in a location exposed to excessive dust or corrosive gases. Moreover, avoid locations subject to heavy vibration or shock, water or oil spray, or e5xx temperatures.

After that, the Temperature Controller automatically adjusts the PID constants using the limit cycle method.

Author: admin