Learn about ASTM A steel mechanical tubing and Atlas Tube’s manufacturing capabilities regarding this product for OEM applications. CALIFORNIA. Arrow Route. Rancho Cucamonga, CA WWW. ASTM A TUBING SPECIFICATIONS. TOLERANCES. ASTM A/AM: Standard Specification for Electric-Resistance-Welded Carbon and Alloy Steel Mechanical Tubing.
|Published (Last):||2 October 2005|
|PDF File Size:||19.29 Mb|
|ePub File Size:||10.12 Mb|
|Price:||Free* [*Free Regsitration Required]|
Historical Version s – view previous versions of standard. Cleanup by Centerless Grinding S2.
This tolerance applies to the speci? E Flash Controlled to 0. Wall Thickness Tolerances, in.
A513 Type 1 & 2 Tubing
A number in parentheses indicates the year of last reapproval. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. Should the order specify that tubing be shipped without rust retarding oil, the?
Nondestructive Electric Test S8.
The purchaser may specify in the order a speci? Committee A01 has identi? Since the sections are special, dies and other tools are not held available. Outside diameter 3 tolerances for cold-rolled steel tubing, sink drawn and DOM, are shown in Table 5. The radii of corners shall be as given in Table In astj specification hard or rationalized conversions apply to diameters, lengths and tensile properties. Measurements on tubing with circumferential lay should be longitudinal.
Soft conversion applies to other SI measurements. Current edition approved March 1, Hydrostatic Test Round Tubing S7. Cleanup by Machining S3. Product analysis, except for rimmed or capped steel, is to be in accordance with usual practice as shown in Table 3.
ASTM A Gr Tube, Size: 1/2 Inch, 3/4 Inch, 1 Inch, 2 Inch, 3 Inch | ID:
Link to Active This link will always route to the current Active version of the standard. This standard is subject to revision at any time by the responsible technical committee and must be reviewed every? Combining values from the two systems may result in non-conformance with the standard.
Both retests for the elements in question shall meet the requirements of the speci? Approved September 1, 1 Revised 3. B Up to 21? Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm. The purchaser and producer may negotiate tolerances on other grades of steel. Any remaining inside diameter? Destructive Weld Tests S6. Outside diameter burr to be removed for measurement.
A513 Square Carbon Steel Tube
NOTE S1—A lot shall consist of all tubes, before cutting aastm length, of the same size and wall thickness which are produced from the same heat of steel and, when heat treated, subjected to the same? Approved May 1, 1 Revised 5. When requested in the order or contract, a report of such analysis shall be furnished to the purchaser.
Mechanical tests shall be performed in accordance with the applicable portions of Test Methods and De? Sstm specification covers round, square, rectangular, and special shape electric-resistance-welded carbon and alloy steel mechanical tubing produced by hot- or cold-rolling.
Tubing shall be free of injurious defects and shall have a workmanlike finish. A — 07 Standard Speci?