ASTM D describes the requirements for sample preparation, tensile testing, and results calculation of flat fiber reinforced polymer (FRP) composite. Standard. Standard number, ASTM-DDM–10 ; ASTM-DD M– Title, Standard test method for determining tensile. ASTM D/DM() Standard Test Method for Determining Tensile Properties of Fiber Reinforced Polymer Matrix Composites Used for.
|Published (Last):||15 December 2017|
|PDF File Size:||1.20 Mb|
|ePub File Size:||8.25 Mb|
|Price:||Free* [*Free Regsitration Required]|
Existing uneven surfaces to receive composite shall be filled with the system epoxy filler or other material approved by the Engineer of Record. If finish is provided beyond 72 hours of the application d765 the epoxy, the surface must be roughened by hand sanding or brush blasting, prior to finishing.
Other components used to attach the Axtm material to the substrate, such as the primer, putty, and adhesive in externally bonded strengthening systems, are excluded from the sample preparation and testing detailed in this document.
Gaps between composite bands may not exceed 0. We are confident that we have what you are looking for. If you like to setup a quick demo, let us know at support madcad. D Terminology for Composite Materials.
Measure square footage of fabric and volume of epoxy used each day. All edges and seams must be feathered.
If no adjacent areas exist, the tests shall be conducted on areas of the installed FRP system subjected to relatively low stress during service.
Any batch that exceeds the batch life shall not be used.
The method only covers the determination of the tensile properties of the FRP composite material. Saturation shall be supervised and checked by zstm certified installer. ASTM D can be used to obtain the tensile force capacity and ultimate tensile strain of FRP material used for qstm strengthening of other structural materials such as, metals, timber, and reinforced concrete. Fabric shall be completely saturated prior to application to contact surface in order to ensure complete impregnation.
E Terminology Relating to Quality and Statistics. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Within the text, the inch-pound units are shown in brackets. Certified applicators shall have the aztm experience and written consent by the FRP manufacturer See Section 1.
ASTM D7565/D7565M – 10(2017)
The method may be used to determine the tensile properties of wet lay-up and pre-impregnated FRP composites fabricated on site or manufactured in a factory setting. Section 03 01 Copyright Compu-tecture, Inc. Review project specifications in detail. Historical Version s – view previous versions of standard.
ASTM D Tensile Properties of FRP Matrix Composites for Civil Structures
SCH fiber — primary carbon fiber, unidirectional. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Any structural member where the installed FRP system does not meet wstm Acceptance Criteria, additional d7556 shall be installed until the FRP meets design requirements, or any other remediation directed by the Engineer of Record.
SEH fiber — primary glass fiber, unidirectional. Under certain application conditions, the system may be placed entirely by hand methods assuring a uniform, even final appearance. Leave the site clean.
The method only covers the determination of the tensile properties of the FRP composite material. The following editions for this book are also available Anchor labels shall have the date of manufacture, the lot number and the minimum weight per unit length for each size. Other components used to attach the FRP material to the substrate, such as the primer, putty, and adhesive in externally bonded strengthening systems, are excluded from the sample preparation and testing detailed in this document.
Variations in the radius along the vertical edge shall not exceed 0. Stormwater General Design Criteria.