Hello, is there a book on how to start using CADSTAR? -or a tutorial anywhere,? my company is loosing patience with me as i struggle to learn. CADSTAR is Zuken’s powerful PCB design solution allowing an intuitive work Throughout CADSTAR’s Schematic and PCB design editors, the menu items. Supporting the potential need to work with PCB designs in the Zuken® CADSTAR™ format, Altium Designer includes a CADSTAR Importer for.
|Published (Last):||24 January 2006|
|PDF File Size:||7.76 Mb|
|ePub File Size:||15.1 Mb|
|Price:||Free* [*Free Regsitration Required]|
Now that you are using signal references and the zone links – are you finding tutoral restricted because they do not appear on other items such as Block Terminals, Bus Terminals etc.
Use a decent grid, if your symbols are drawn on a coarse th grid then place them on that, connect to them on a minimum of 25th.
I have been a bit busy of late, things I wanted to blog about I have held off because of a cadtar technical issues I did not feel I should post. Sunday, 8 May Preparing a schematic template with zone link support. Suggestions on how to get more reading it would be most welcome. You came to the right place!
Hey folks – if your going to post comments could you please leave a name? By this I mean, for instance – an attribute such as Value, Package, Voltage etc or perhaps a component outline or a pad cadstae so on. Catch 20 really, if no one looks I wont post, if I don’t post no one looks. Part and Inventory Search. Sorry folks – its been a busy time recently with the run up to Christmas and I have not had time to put anything together.
CADSTAR tutorial or book
You can download a free Altium Designer Viewer license which is valid for a 6 months. Casstar the help that comes with cadstar, it has lots of info in it. Now I just need to pull my finger out and make enough posts to warrant you visiting it on your phone: Download Altium Designer Installer.
Well of course it does not work – its only a toy one, but if you asked these questions to a car mechanic they would want to know a little rutorial about what is wrong with it, has the wheel fallen off? Thursday, 13 September How to make a new part based on an existing library part.
If you have any doubt you can contact their support also there is one community, on yahoo gruops, of Cadstat users. Its been a busy few months. While I know where it it and it is supposed to carstar for sharing your files it is generally better to put your shared files on a network shared drive etc.
Wednesday, 16 June Life is much better with multiple monitors. Distorted Sine output from Transformer 8. Routing with incremental track widths in P. You may receive communications from Altium and can change your notification preferences at any time. So how do you add a simple resistor similar to an existing one into your library? So if you do as I have advised then you may also need to take ownership of the Zuken folder and all subfolders below it.
The question was – How to do this? Part LibraryTip. Just a note to say – I noticed that in the blog setup there was an option for a mobile theme, so I have enabled it to allow the blog to be read better via a mobile.
GC-Prevue the drill files are offset from the Gerbers.
Demonstration Movies of Key Features
Generally the reason for this is that the driver installation does a port check and detects that the port that it uses is already in use so rather than create a conflict it will stop and rewind the installation. Need a Microchip Pic or Xilinx processor, there are over It is designed to allow you to temporarily leave a connection dangling while you sort out something for it to connect to.
However typing it manually is very likely to result in a typo, copying it in Windows Explorer only copies the path. Digital multimeter appears to have measured voltages lower than expected.