LENZE 8600 MANUAL PDF

View and Download Lenze series operating instructions manual online. Inverter Drives Variant Dancer-position control with Torque control. series. vector. System/Component overview. Lenze. FU vector en 11/ 3. System overview/Selection guide. Communication modules e.g. keypad or. PROFIBUS. Get Lenze IB Manual. Get all Lenze manuals! with optical fibre cable together with the controller series as of E DC controller E 5x. 6x.

Author: Dushakar Gazuru
Country: Thailand
Language: English (Spanish)
Genre: Environment
Published (Last): 26 August 2016
Pages: 382
PDF File Size: 10.91 Mb
ePub File Size: 17.27 Mb
ISBN: 943-2-93956-542-9
Downloads: 41856
Price: Free* [*Free Regsitration Required]
Uploader: Mujind

Please note that in configurations with additional setpoints, the setpoint 2 is set to zero, as long as a JOG frequency is active. Either the value or a fault indication is output. Page of Go. The controller is enabled RFR.

Process input data description hex Data format: Basic Settings Basic settings Operating mode The controllers of the series offer different interfaces.

Adjustment of the dancer-Position controller 9. The permissible continuous output powes rises the same way.

The modules and are available are Options and tan be integrated into the controller See also page Variant Communication medium Service no. Only required for lene module: This symbol refers to items of information intended to facilitate operation.

Therefore, the following files are saved in the DOS format on the attached diskette: Adjustment Of The Io Setpoint Page 9 12 Serial intetfaces Page 46 The parameter communication 860 the controller has the following sequence: S-shaped ramp generator characteristic For the ramp generator of the main setpoint you penze select two different characteristics under Cl When using several mounting plates they must be connected with as large surface as possible e-g.

  BADLANDS MALICK PDF

All cables from and to t3e controller must be screened.

Lenze – : DACPOL-SERVICE

Notes which mannual be observed to avoid possible damage to or destruction of equipment. Face value factor Bhex The parameter “face value factor” is used to change the resolution or the setting range of the set-value input.

V on request The scope of supply of the IB module includes the following components: The controller is inhibited RSP and waits for comand lene shutdown. The arrow Position marks whether you are in the code or in the Parameter level.

Lenze series Manuals

Adjustment of the act. There are two parameters in addition. Furthermore, these Signals tan be adjusted in the best possible way by setting facilities. Gain Adjustment – Radius Signal 9. As standard, you can connect a maximum of 32 participants including hosts to the RS bus. Features of setpoint 2 co It then switches automaticaly to the state “switch-on disabled”.

  JAALALA DHUGAA PDF

That means, the drive could accelerate to fmax while adjusting the inputs when the setting controller enable is activated, although only a very small setpoint was Lecom2 Interface option Usually the field frequency Pilot control is not used for the loop control. The parameter is mapped via the ramp-min function to the Lenze deceleration ramp L-C If they are different, there is a defective.

Base setting of the controller In this phase the controller receives information about additional ,anual and the source of the control information.

Configuration – Lenze EDS4900U-REG User Manual

Meaning Controller available? At the moment, there are 21 EC directives of product the member states. To locate information on specific topics, simply refer to the table of contents at the beginning and to the index at the end of the operating instructions. Selection Of The Mains Choke 6. Resistance [Q] 2 required brake peak power Depending on the unit the resistances must not fall below the Depending on the unit the resistances must majual fall below the following values:

Author: admin